News

Directive (EU) 2024/2853 on defective product liability supersedes the 1985 Product Liability Directive, applying to goods launched on the EU market from 9 December 2026. For playground equipment, the applicable safety standard still remains EN 1176; the key change concerns liability parties in injury claims. Non-EU manufacturers remain liable, while EU importers, authorised representatives, fulfilment service providers, and in specified circumstances distributors and online platforms, are all identifiable defendants. This directive also establishes presumptions of defect and causation: courts may rule a product defective if the defendant withholds relevant evidence or the product fails mandatory safety rules. Relevant evidence covers the CE technical file, risk assessment and test reports.<g0-textarea-recorder-host id="g0-textarea-recorder"></g0-textarea-recorder-host>

<g0-textarea-recorder-host id="g0-textarea-recorder"></g0-textarea-recorder-host>

<g0-textarea-recorder-host id="g0-textarea-recorder"></g0-textarea-recorder-host>

A public playground tender is decided before any supplier responds, by the specification, the documentation schedule and the evaluation criteria. The process runs in four stages: the authority writes the specification, the suppliers respond to it, the responses are scored against published criteria, and the winning contract sets out what is delivered and what has to be demonstrated before handover. The three parts of a tender that most often go wrong are the evaluation criteria, the documentation schedule and the site conditions information, and each of them can be corrected before the tender opens while none of them can be corrected afterwards without reopening the process. This guide covers how a public playground tender is structured, what evidence a supplier has to provide, how insurance and liability requirements differ from a private purchase, and what a buyer should confirm about ground conditions before the tender documents are issued.

Playground equipment in a cold climate fails in a predictable order: water first, then the surfacing, then the fixings, then the coating. A playground used from October to March has to be specified as a winter installation, with a surfacing tested at low temperature, a sub-base that drains in a freeze, stainless fixings for anything a child can touch, and a written operating routine for the site staff. Four decisions drive the rest of the specification: the minimum operating temperature for the surfacing, the material of the fixings, the free height of fall under every element, and the closure rule. This guide sets out how cold weather changes the material choice for custom playground equipment, what has to be done to the drainage before the first frost, how surfacing behaves once the temperature drops, which components fail first, and how to build an operating routine that a site team can follow.

Two playground equipment quotations for the same project often describe different products. A comparable quotation names every model, gives dimensions in millimetres, states the material grade and coating system, lists the third-party test report, and separates supply from shipping, foundations, surfacing, installation and certification. This guide shows what each quotation line must contain, the nine cost lines that are usually excluded, how to verify a certification claim, and how to read a quotation as a bill of quantities.

Playground equipment is fixed to the ground, so the ground decides whether the installation lasts. A foundation transfers the load from the play structure into the soil or the concrete, and an anchor is the bolted connection between that foundation and the steel post. A compact soil site, a paved slab, a roof deck and a coastal sand site each need a different detail, with the standard public reference values being 600 mm depth on firm soil, a 400 mm footing in C25/30 concrete, 4 anchors per post and a recorded compaction test for every footing.

Importing playground equipment into Saudi Arabia or another Gulf market is a document process before it is a shipping process. A buyer needs a SABER product conformity certificate for the model, a SABER shipment conformity certificate for each consignment, a Gulf conformity mark where the category requires one, and test reports from an ISO/IEC 17025 accredited laboratory. The importer in the destination country holds the SABER account, the shipment certificate has to exist before the goods arrive, and the Arabic labelling and permanent origin marking must be built into the manufacturing design rather than added at the end.